ARBITRARY WAVEFORM GENERATOR UNIT U8793 en Nagano, Japón
Nuevo
Doubleclick to zoom in
Contacte al vendedor
para más fotos y información.
Especificaciones
- Condición
- nuevo
- Output terminal
- Number of channels: 2, SMB terminal (Output impedance: 1 Ω or less) Max. rated voltage to ground: 30 V rms AC or 60 V DC
- Output voltage range
- -10 V to 15 V (Amplitude setting range: 0 V to 20 V p-p, Setting resolution: 1 mV)
- Max. output current
- 10 mA (Allowable load resistance: 1.5 kΩ or more)
- Function generator
- DC, Sine wave, Square wave, Pulse wave, Triangular wave, Ramp wave, Output frequency: 10 mHz to 100 kHz
- Arbitrary waveform generator mode
- Waveforms measured by MR8847A, etc., generated by Hioki Model 7075, PQ3198, or SF8000, CSV waveforms D/A refresh rate: 2 MHz (using 16-bit D/A)
- Sweep function
- Frequency, Amplitude, Offset, Duty (Pulse only)
- Program function
- Max. 128 steps (Number of loops for each step, Number of total loops)
- Other
- Self-test function (Voltage), External input/output control
- Dimensions and mass
- 106 mm (4.17 in) W × 19.8 mm (0.78 in) H × 196.5 mm (7.74 in) D, 250 g (8.8 oz)
- Included accessories
- None
- Categoría
- Generadores de pruebas en Japón
- Subcategoría
- Memory recorder options
- ID de Anuncio
- 61137836
Descripción
The Arbitrary Waveform Generator Unit U8793 is a plug-and-play module for the Hioki Memory HiCorder to create a function generator, arbitrary waveform generator, and waveform measurement in a single device. Easily observe waveforms while varying test conditions, such as changing the signal's amplitude and frequency as well as programming various waveforms to output in order.
Output arbitrary waveform signals up to 2 channels
Output problematic waveforms recorded with the Memory HiCorder up to 15 V
Output customized arbitrary waveforms signals up to 15 V
For use with Hioki Memory HiCorder series (cannot use with 8847 or MR8847)
Built-in function generator and sweep function
Isolated between unit and output, and between all channels
After you install the included SF8000 Waveform Maker software on your computer, you can create waveforms easily by either entering them directly or by entering the formulas behind them. You can also quickly add noise and multiply waveforms.