Low Temperature Thermal Cycle Test Chamber -70℃ en Xi'an, Shaanxi, China
Nuevo
Doubleclick to zoom in
Contacte al vendedor
para más fotos y información.
Especificaciones
- Condición
- nuevo
- Place of origin
- China
- Certification
- CE，RoHS
- Name
- Thermal Cycle Test Chamber
- Internal dimension (mm)
- 500*600*750
- Overall dimension (mm)
- 960*1150*1860
- Temperature range (℃)
- A: -20℃ ～+150 ℃ B:-40℃ ～+150 ℃ C:-70℃ ～+150 ℃
- Humidity range (r.h)
- 20% ~ 98% RH
- Temperature fluctuations
- ± 0.5 ℃
- Temperature deviation
- ± 2.0 ℃
- Humidity deviation
- ± 2.5% RH
- Heating rate
- 3 ℃ / min
- Cooling rate
- 1 ℃ / min
- Interior volume
- 500 liters
- Controller
- PLC,PC Link, R-232 Interface,USB,APP
- Cooling system
- Mechanical compression refrigeration system
- Interior material
- SUS304 stainless steel
- Maximum noise
- 65 dBA
- Power supply
- 380V
- Automatic water inlet
- Cable Hole
- Low type
- -20℃/-40℃/-60℃/-70℃/-86℃
- Humidity range
- 10% - 98% RH
- Temperature range
- -20℃ ～+150 ℃
- Exterior material
- A3 Steel Plate
- High light
- Low Temperature Thermal Cycle Test Chamber, -70C Thermal Cycle Test Chamber, -70C temperature cycling test chamber
- Categoría
- Cámaras climáticas en China
- Subcategoría
- Humidity test chamber
- ID de Anuncio
- 66095715
Descripción
Low Temperature Thermal Cycle Test Chamber -70℃
Description
Low Temperature Thermal Cycle Test Chamber,The purpose of humidity temperature chambers is to create artificial conditions inside a controlled cabinet and test effects on product samples. These chambers are used by semiconductor, automobile, cement, food and pharmaceutical companies to test their samples at various temperatures and humidity ranges (damp and heat test) before launching their final products; some of applications are Damp Heat Test and Tropical Exposure etc.
Main Technical Parameter
Deatil
●Temperature and humidity sensor: The temperature humidity sensor is located in the chamber workspace to monitor the temperature humidity levels the product is experiencing.
●Cable Hole: A standard test hole, located at the left side of the work room, is provided with a sleeve inside to prevent moisture from entering the insulation layer. Equipped with flange. The standard inner hole diameter is 50mm. Soft silicone plug seal;