Cat C18 Auxiliary/Generator Set Engine (IMO II) en Mesa, Arizona, USA
Usado
Doubleclick to zoom in
Contacte al vendedor
para más fotos y información.
Especificaciones
- Condición
- usado
- Minimum rating
- 404 BHP
- Maximum rating
- 660 BHP
- Aspiration
- TA, TTA
- Dry weight
- 1,950 lb
- Width
- 44.6 in
- Length
- 73 in
- Height
- 51.2 in
- Stroke
- 7.2 in
- Configuration
- In-Line 6, 4-Stroke-Cycle Diesel
- Displacement
- 1,106 in³
- Bore
- 5.7 in
- Rotation from flywheel end
- Counterclockwise
- Power range
- 404 - 660
- Categoría
- Grupos electrógenos en USA
- Subcategoría
- Auxiliary engines
- ID de Anuncio
- 82813584
Descripción
Separate circuit after-cooled (SCAC)
Open Crankcase Ventilation (OCV) system
Turbocharger, jacket water cooled
Turbocharger inlet, 152 mm (6 in) OD straight connection
Programmable low idle
Electronic diagnostics and fault logging
Electronic fuel/air ratio control
Engine Protection Mode for extended ambient conditions - EPA Tier 3 Ratings Only
70-pin customer connector
Three types of throttle inputs (primary/ secondary PWM, 0-5V, 4-20mA
Separate Circuit After-Cooling (SCAC) for both HEX and Keel cooled engines
Engine JW and SCAC Shell & Tube Heat Exchangers for HEX cooled engines
SCAC pump, gear driven, for HEX cooled engines only
Jacket water pump, gear driven
Auxiliary water pump, gear driven
Sea water pump, bronze impeller, gear driven
SCAC and JW shunt tanks for maintaining proper pump inlet pressures
152 mm (6 in) round flanged outlet
Water-cooled exhaust manifold & turbocharger
Flywheel Housing, SAE No. 0
Flywheel, 18 inch, 136 teeth
SAE standard rotation