Usado en Nagano, Japón

ALDAS-α : EIS MEASUREMENT SYSTEM

Measurement target: Electrolysis cell, fuel cell | Measurement parameters: Impedance ​(R,​X,​θ,​Z)​, voltage ​(V),​ current ​(I) | Measurement modes: EIS Mode, Logging Mode | Max. input voltage: 20 V | Max. measu...

BATTERY IMPEDANCE METER BT4560-60

Allowable input voltage: Up to 5 V | Measured items: Impedance, voltage, temperature | Impedance measurement: Parameters: R (resistance), X (reactance), Z (impedance), θ (phase angle) Frequency: 0.01 Hz to 10.00 ...

Slurry Analytical System (Standalone Analysis Software)

System requirements (computer): OS: Windows 10, Windows 11 RAM: 8 GB or more Storage: 1 GB or more of available space Display: resolution 1920 × 1080 or more is recommended Interface: USB 2.0 / 3.0, LAN .NET Fram...

POWER ANALYZER PW4001

Measurement lines: Single-phase 2-wire, single-phase 3-wire, three-phase 3-wire, three-phase 4-wire | Number of channels: 4 (4 voltage, 4 current, isolated between each channel) | Measurement frequency bandwidth:...

MEMORY HiCORDER MR8848

Measurement functions: Memory function (waveform recording), Recorder function (peak/trough recording), X-Y Recorder function, FFT function | Max. number of channels: 16 ch analog + 16 ch logic 32 ch analog + 16 ...

POWER MEASUREMENT MODULE M7103

Compatible models: Data Logger LR8101: Standard model Data Logger LR8102: Advanced model | Operating temperature and humidity range: 0°C to 40°C (32°F to 104°F), 80% RH or less (non-condensing) | Measurement line...

HIGH VOLTAGE MULTIPLEXER SW2001

Input channels: 2 channels of high-voltage, 2-terminal input: insulation and withstanding voltage tester input, impulse winding tester input 2 channels of low-voltage, 4-terminal input: LCR meter input, resistan...

PARTIAL DISCHARGE DETECTOR ST4200

Detection method: Discharge current detection using CT and digital filters Conforms to the detection method in IEC 61934 Edition 2.0. | Test frequency range (applied voltage): 45 Hz to 1.1 kHz | Charge quantity m...

ALDAS-Mini : ELECTROLYSIS CELL ANALYZER

Measurement target: Electrolysis cell, cell stack | Measurement parameters: Impedance ​(R,​X,​θ,​Z)​, voltage ​(V),​ current ​(I) | Measurement modes: Logging mode, Nyquist plot mode, Bode plot mode | Max. input ...

AC/DC CURRENT PROBE CT6834, CT6834-01

Rated current: 500 A AC/DC | Frequency bandwidth: DC to 50 kHz | Diameter of measurable conductor: Max. φ20 mm (0.79 in.) | Maximum peak current: Up to ±800 A peak are permitted at a temperature of 40°C (104°F) o...

AC/DC CURRENT PROBE CT6833, CT6833-01

Rated current: 200 A AC/DC | Frequency bandwidth: DC to 50 kHz | Diameter of measurable conductor: Max. φ20 mm (0.79 in.) | Maximum peak current: Up to ±600 A peak are permitted at a temperature of 40°C (104°F) o...

RESISTANCE METER RM3548-50

Resistance range: 3 mΩ (3.5000 mΩ display Max., 0.1 µΩ resolution) to 3 MΩ range (3.5000 MΩ display Max., 100 Ω resolution), 10 steps Measurement accuracy: ±0.020 % rdg. ±0.007 % f.s. | Testing current: [at 3 mΩ ...

POWDER IMPEDANCE MEASUREMENT SYSTEM

Frequency at which measurements can be made: DC to 5 MHz (Three types of measuring instruments used) | Load application method: Manual operation (constant control of load is not possible) | Load range (compressin...

HIGH VOLTAGE INSULATION TESTER IR5050

• Fabricante: HIOKI E.E

Measurement parameters: • Insulation resistance • Leakage current • Voltage • Capacitance (DD function) | Max. rated voltage to terminals: 1000 V AC, 2000 V DC | Max. rated voltage to ground: 1000 V (CAT IV), 600...

HIGH VOLTAGE INSULATION TESTER IR5051

• Fabricante: HIOKI E.E

Measurement parameters: • Insulation resistance • PV insulation resistance • Leakage current • Voltage • Capacitance (DD function) | Max. rated voltage to terminals: 1000 V AC, 2000 V DC | Max. rated voltage to g...